Brackets are mounted. Wayne is about half way done with PCB.
Date: 07/15/2010
Views: 2965
DSCF0007_001
Date: 07/27/2009
Views: 2902
CH8_1
Date: 12/31/1969
Views: 5294
Newest Image
EAA SITE
Date: 08/23/2023
Views: 84073
Revised gear and door warning schematic.
This schematic was revised to source power to main gear relay coil as to avoid having to run another wire aft.
DOOR WARNING:
**Alive above 20% throttle, should allow taxi with door opened
GEAR WARNING
**Alive below 20% throttle or below ~ 70 Knots
**Soaring allows gear warning to be dead until airbrake is moved out of closed position
GEAR HORN SILENCING:
**Timer switch to turn off ~ 1 minute or so, (adjustable)
Circuit board will be located on aft side of port headrest.
LED annunciator and horn extinguish switch to be located in ceiling.
Horn to be located inside port headrest.
See:
Electric shop Deluxe Deducts DeBucks! High amp "light" batteries and fat wires, high and low amp "very" thin wires and integrated headrests.
For install:
http://www.europaowners.org/forums/gallery2.php?g2_itemId=30710&g2_page=2
Y10-06-11