|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 10963
|
|
|
dsc09023
Ensure you have a good key. I used the drill press to create the dimples. These will be filled with 420 and flox when doing the glass layups.
Date: 01/22/2013
Views: 7193
|
|
|
dsc08633
We had to put the plane somewhat down near the trailer with the main up so that we could get the right contour for the ribs. Reminds me of a B-17 with the main just showing.
Date: 04/14/2012
Views: 6316
|
|
|
dsc08640
OK not the best shot but here you can see I used the jack to move the rear rib in place under the airframe being careful not to pinch the belly. I then secured the rib in place but using some drywall screws in the 2x6. This way any weight will be transf
Date: 04/15/2012
Views: 6811
|
|
|
p1000468
p1000468.jpg
Date: 12/09/2011
Views: 28548
|
|
|
dsc09034
Starboard side done. Pic taken before a little clean up.
Date: 01/22/2013
Views: 6495
|
|
|
dsc09030
Starboard side done.
Date: 01/22/2013
Views: 7233
|
|
|
20141102_153539
Out. Ad you can see the screw is sill in the nut plate. it came out later.
Date: 11/02/2014
Views: 14051
|
|
|
p1000710
p1000710.jpg
Date: 03/12/2012
Views: 5389
|
|
|
nex_2014_01_25_01
Starboard side after Uni over ribs 3 and 4. Added Bid on the X to reinforce the cuts needed to get the Uni to lay flat. Also filled in Rib 1 air buble.
Date: 01/25/2014
Views: 5989
|
|
|
dsc08639
More of the same. I was going to cut the carpet and form it to the ribs and staple it in place but decided that was just a time vampire and pointless since the airframe is holding it in place.
Date: 04/15/2012
Views: 6654
|
|
|
nex_2013_08_24_06
Time for some clean up.
Date: 08/25/2013
Views: 6105
|
|
|
p1000697
p1000697.jpg
Date: 03/12/2012
Views: 5758
|
|
|
Actual part.
Actual part.
Date: 04/03/2016
Views: 11668
|
|
|
nex_2014_01_25_04
Bill helping hoist the aircraft up to remove the jig.
Date: 01/25/2014
Views: 6228
|
|
|
p1000714
p1000714.jpg
Date: 03/12/2012
Views: 5455
|
|
|
20160403_160502.jpg
20160403_160502.jpg
Date: 04/03/2016
Views: 11218
|
|
|
dsc09064
Bill does nice peel ply work!
Date: 01/24/2013
Views: 7022
|
|
|
p1000701
p1000701.jpg
Date: 03/12/2012
Views: 5461
|
|
|
dsc08638
I used some thick good quality carpet to pad the ribs.
Date: 04/15/2012
Views: 6418
|
|