http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/ en-us Gallery 2 RSS Module, version 1.1.8 Fri, 24 Apr 2026 15:12:48 +0000 120 http://www.europaowners.org/gallery2/d/429019-4/MOD72.jpg http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/ http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/DSC00850.JPG.html http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/DSC00850.JPG.html
If I can't slide this gauge in, I'll try the .003" under. I may need to try and enlarge any undersized areas or make the inserts smaller in OD in that area.

Y13-12-27]]> rparigoris photo Fri, 27 Dec 2013 17:21:50 +0000 http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/DSC00847.JPG.html http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/DSC00847.JPG.html
I have a precision micrometer that I measured the inserts with.
They vary in diameter by ~ .001", I used the average and made this side .003" undersized.

Y13-12-27]]> rparigoris photo Fri, 27 Dec 2013 17:17:47 +0000 http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/DSC00846.JPG.html http://www.europaowners.org/gallery2/v/Begin-06-2003/Firewall+forward/album286/MOD72/DSC00846.JPG.html
I have concerns that the reamer I borrowed from Bob Borger may not have done as good a job as I would have liked.
If that's the case, especially near welds, I could get the inserts plenty stuck but not all the way inserted.
Thus I made a Go No-Go gauge to feel how things are doing.
One side is ~ .001" undersized and the other .003" undersized.

Y13-12-27]]> rparigoris photo Fri, 27 Dec 2013 17:15:21 +0000