|
|
IMGA0716
Cracked off the jig, flipped over, and there we go iv got half a wing!!
Date: 04/23/2013
Views: 96401
|
|
|
IMGA0754
These straps are great, one down one to go
Date: 05/05/2013
Views: 86876
|
|
|
|
IMGA0572
Date: 03/17/2013
Views: 87844
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 98499
|
|
|
|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 100558
|
|
|
IMGA0661
Screws through ribs to align blocks.....must remember to remove them before the lay up
Date: 04/17/2013
Views: 86983
|
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 93008
|
|
|
IMGA0623
Date: 04/09/2013
Views: 73243
|
|
|
|
IMGA0756
Some dry micro to stick the block to the spar
Date: 05/05/2013
Views: 89152
|
|
|
IMGA0626
Hole ready for stall warner
Date: 04/11/2013
Views: 69084
|
|
|
|
IMGA0660
You can see the wash out build into the block
Date: 04/17/2013
Views: 88058
|
|
|
IMGA0680
These are the rear blocks where the bell cranks sit in. Note the vent holes
Date: 04/18/2013
Views: 109281
|
|
|
|
IMGA0589
Date: 03/29/2013
Views: 101303
|
|
|
IMGA0811
Flap closeout
Date: 05/14/2013
Views: 96571
|
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 89167
|
|
|
IMGA0737
The small bloke with two mounting plates at the outrigger position.
Date: 04/26/2013
Views: 103074
|
|
|
|
IMGA0657
After repair
Date: 04/17/2013
Views: 77148
|
|
|
IMGA0585
Date: 03/18/2013
Views: 91482
|
|
|
|
IMGA0635
Rib ready for floxing
Date: 04/14/2013
Views: 71141
|
|
|
IMGA0770
Two are a time baby yeah!!!!!
Date: 05/10/2013
Views: 75992
|
|
