|
|
IMGA1259
Not bad looking for a classic wing if i do say so myself. Had to make a wing dolly for easier manoeuvrability round the shop.
Date: 09/23/2013
Views: 251545
|
|
|
IMGA0800
all that work then you have to cut a big chunk out!!
Date: 05/13/2013
Views: 67364
|
|
|
|
IMGA0811
Flap closeout
Date: 05/14/2013
Views: 93045
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 89805
|
|
|
|
IMGA0833
Remove trailing edge support ready for skin lay up
Date: 05/17/2013
Views: 85714
|
|
|
IMGA0878
Wing rib close outs
Date: 05/30/2013
Views: 81109
|
|
|
|
IMGA1030
Wing tips prepped for shaping thanks to Tony K's web blog on his kit #272
Date: 08/08/2013
Views: 83746
|
|
|
IMGA1057
And a few hours later.......
Date: 08/09/2013
Views: 80232
|
|
|
|
IMGA0785
One side done. A straight edge is bonded on to aid rigidity once some of the foam is cut away
Date: 05/12/2013
Views: 72012
|
|
|
IMGA0756
Some dry micro to stick the block to the spar
Date: 05/05/2013
Views: 86681
|
|
|
|
IMGA0754
These straps are great, one down one to go
Date: 05/05/2013
Views: 83340
|
|
|
IMGA0770
Two are a time baby yeah!!!!!
Date: 05/10/2013
Views: 73759
|
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 86610
|
|
|
IMGA0722
Just testing out the rear blocks for an idea what it will look like
Date: 04/24/2013
Views: 87875
|
|
|
|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 97862
|
|
|
IMGA0716
Cracked off the jig, flipped over, and there we go iv got half a wing!!
Date: 04/23/2013
Views: 93676
|
|
|
|
IMGA0732
The other rear blocks, laying up the ribs and including the mounting plates for the flap hinges.
Date: 04/25/2013
Views: 103512
|
|
|
IMGA0737
The small bloke with two mounting plates at the outrigger position.
Date: 04/26/2013
Views: 99994
|
|
|
|
IMGA0701
First wings L.E layed up and peel plyed. The blue foam is keeping in place a 90 degree strip which is keeping the end of the uni cloth bent under to aid bonding to the rear of the spar. A helpful tip from Mike Gregory.......Oh wanted to say it took 8 and
Date: 04/20/2013
Views: 105440
|
|
|
IMGA0707
The next day me and my helper Ang did the other wing. This time it only took 6 and half hours so left us time to trim the other wing
Date: 04/21/2013
Views: 95281
|
|
