|
|
DSCN0034
Date: 10/10/2009
Views: 5648
|
|
|
Supplied nuts are too thick for the thin side of the tang 2.
Date: 10/14/2009
Views: 5252
|
|
|
|
Port aft hinge mounted as well.
Date: 10/15/2009
Views: 5399
|
|
|
This is the gap at high point on port door.
Date: 10/15/2009
Views: 5784
|
|
|
|
Mounted top port front hinge.
Date: 10/15/2009
Views: 5360
|
|
|
Token counterbore.
Date: 10/14/2009
Views: 5031
|
|
|
|
Port front spacer perfectly bonded in position.
Date: 10/14/2009
Views: 6991
|
|
|
Port aft spacer perfectly bonded.
Date: 10/14/2009
Views: 5694
|
|
|
|
4 nuts sanded down to .125"
Date: 10/14/2009
Views: 5342
|
|
|
Supplied nuts are too thick for the thin side of the tang 1.
Date: 10/14/2009
Views: 4827
|
|
|
|
Nice fit.
Date: 10/14/2009
Views: 5285
|
|
|
Used a 1/8" piloted 100 degree counterbore to counterbore hinges.
Date: 10/14/2009
Views: 6609
|
|
|
|
Used these tools to measure gap.
Date: 10/14/2009
Views: 5812
|
|
|
Bonding port front spacer to fuse with JB KWIK weld.
Date: 10/12/2009
Views: 6494
|
|
|
|
Bonding port aft spacer to fuse with JB KWIK weld.
Date: 10/12/2009
Views: 6086
|
|
|
Trimmed tang overhang inboard of the inboard edge of hinge leaving thickness of tang plus 10%.
Date: 10/12/2009
Views: 5835
|
|
|
|
Once door is removed will countersink top half of hinge.
Date: 10/12/2009
Views: 6964
|
|
|
Port aft spacer is thinner than front.
Date: 10/12/2009
Views: 5457
|
|
|
|
Used the 1/4-20 bondable stud in drill press to proper position door.
Date: 10/12/2009
Views: 6424
|
|
|
Port front spacer complete and held in place with double sticky tape.
Date: 10/12/2009
Views: 5654
|
|
