|
|
Now you can see lightening holes onthe small offsetting plate
Date: 11/28/2013
Views: 7925
|
|
|
Front HardPoint 8
Date: 12/27/2013
Views: 10206
|
|
|
|
Emergency Maneuver that starts with Heim? 13 of 13
Date: 12/16/2013
Views: 8129
|
|
|
I'm going to Redux the nut in place and Redux/Flox the thread extender hang-over
Date: 12/13/2013
Views: 6675
|
|
|
|
1/8" 4130 bracket
Date: 11/27/2013
Views: 7535
|
|
|
Reinforcement
Date: 11/27/2013
Views: 10099
|
|
|
|
Mill round slot in master cylinder 5 of 12
Date: 12/23/2013
Views: 8997
|
|
|
Prior to work Y13-12-15 (compare to prior pic)
Date: 12/13/2013
Views: 7850
|
|
|
|
Front threaded rod cut down to .450 (I aim for minimum of 9.5 threads of engagement on any 5/16-24 joint)
Date: 12/13/2013
Views: 7617
|
|
|
Mill round slot in master cylinder 1 of 12
Date: 12/23/2013
Views: 7753
|
|
|
|
Cut down Heims to 1.700"
Date: 12/13/2013
Views: 6765
|
|
|
I failed a bearing on purpose
Date: 11/27/2013
Views: 14896
|
|
|
|
Spar clamp that allows a little fore and aft movement
Date: 11/27/2013
Views: 9240
|
|
|
Cut down 1" aft threaded rod to .700"
Date: 12/13/2013
Views: 7743
|
|
|
|
Front HardPoint 7
Date: 12/27/2013
Views: 10258
|
|
|
The center hole was tapped and used for 1st test mount, a big lightening hole will eliminate it
Date: 11/27/2013
Views: 8427
|
|
|
|
ESTM-20 Specification Sheet
Date: 11/28/2013
Views: 7858
|
|
|
I bored this 5/8" Stainless Lock Washers to .785", 11/16" is a wierd size that McMaster didn't offer
Date: 12/16/2013
Views: 8211
|
|
|
|
Emergency Maneuver that starts with Heim? 1 of 13
Date: 12/16/2013
Views: 8402
|
|
|
Oops, several dents being repaired in Port seat base, Q-Cel, 1 BID, Peel-Ply
Date: 11/30/2013
Views: 9042
|
|
