|
|
Mill round slot in master cylinder 5 of 12
Date: 12/23/2013
Views: 9291
|
|
|
Paint complete
Date: 11/29/2013
Views: 9288
|
|
|
|
Cable Happy in Spar Tunnel 1
Date: 12/12/2013
Views: 9285
|
|
|
Emergency Maneuver that starts with Heim? 12 of 13
Date: 12/16/2013
Views: 9274
|
|
|
|
5.4 oz. for bracket, pillow block and pillow block mounting hardware
Date: 11/29/2013
Views: 9227
|
|
|
Oops, fixed a dent I made with a C-Clamp when testing spar Adel clamp bracket, Q-Cel, 1 BID and Peel-Ply
Date: 11/30/2013
Views: 8818
|
|
|
|
1/2" ball end-mill on order (McMaster) to to mill a pocket in the brake master cylinder directly above the mounting holes
Date: 12/13/2013
Views: 8777
|
|
|
Cable Happy in Spar Tunnel 2
Date: 12/12/2013
Views: 8749
|
|
|
|
Oops, a few air bubles on aft mount reinforcemelay-up, drilled holes, filled with Aeropoxy, plugged with dry flox and Peel-Ply
Date: 11/30/2013
Views: 8735
|
|
|
The center hole was tapped and used for 1st test mount, a big lightening hole will eliminate it
Date: 11/27/2013
Views: 8711
|
|
|
|
Mill round slot in master cylinder 7 of 12
Date: 12/23/2013
Views: 8704
|
|
|
Emergency Maneuver that starts with Heim? 1 of 13
Date: 12/16/2013
Views: 8698
|
|
|
|
Eric Engineering bending moment of tube with bends
Date: 12/03/2013
Views: 8675
|
|
|
Mill round slot in master cylinder 9 of 12
Date: 12/23/2013
Views: 8650
|
|
|
|
Emergency Maneuver that starts with Heim? 4 of 13
Date: 12/16/2013
Views: 8623
|
|
|
Cable Happy near Fuel Selector and below Air-Brake Cable 1
Date: 12/12/2013
Views: 8568
|
|
|
|
Overall shot of push-rod replacement
Date: 12/13/2013
Views: 8564
|
|
|
Straight ahead
Date: 11/27/2013
Views: 8493
|
|
|
|
I bored this 5/8" Stainless Lock Washers to .785", 11/16" is a wierd size that McMaster didn't offer
Date: 12/16/2013
Views: 8486
|
|
|
Clevis Fork dimensions after material removal
Date: 12/16/2013
Views: 8438
|
|
