|
|
1/2" clamps that allow cable to slide 2 of 2
Date: 12/16/2013
Views: 10243
|
|
|
I failed a bearing on purpose
Date: 11/27/2013
Views: 14894
|
|
|
|
Oops, fixed a dent I made with a C-Clamp when testing spar Adel clamp bracket, Q-Cel, 1 BID and Peel-Ply
Date: 11/30/2013
Views: 8533
|
|
|
Mill round slot in master cylinder 8 of 12
Date: 12/23/2013
Views: 7889
|
|
|
|
Emergency Maneuver that starts with Heim? 1 of 13
Date: 12/16/2013
Views: 8401
|
|
|
The center hole was tapped and used for 1st test mount, a big lightening hole will eliminate it
Date: 11/27/2013
Views: 8424
|
|
|
|
1/4-28 jam nuts
Date: 11/27/2013
Views: 7296
|
|
|
Front HardPoint 8
Date: 12/27/2013
Views: 10203
|
|
|
|
Front HardPoint 4
Date: 12/27/2013
Views: 10292
|
|
|
Using fore and aft the supplied by Europa for push-rod jam nuts that are .155" thick
Date: 12/13/2013
Views: 6892
|
|
|
|
Front HardPoint 5
Date: 12/27/2013
Views: 11621
|
|
|
Front Cable Mount with Lever in Down Position
Date: 12/12/2013
Views: 7116
|
|
|
|
Emergency Maneuver that starts with Heim? 3 of 13
Date: 12/16/2013
Views: 7301
|
|
|
Prior to work Y13-12-15 (compare to prior pic)
Date: 12/13/2013
Views: 7848
|
|
|
|
I bored this 5/8" Stainless Lock Washers to .785", 11/16" is a wierd size that McMaster didn't offer
Date: 12/16/2013
Views: 8211
|
|
|
Results of fitting in situation.
Date: 11/27/2013
Views: 7968
|
|
|
|
Aft mount
Date: 12/13/2013
Views: 6633
|
|
|
You can see I left a little space so the spacer can pinch the bearing when the nut is tightened
Date: 12/13/2013
Views: 7040
|
|
|
|
Half the weight was eliminated since I first cut steel
Date: 11/27/2013
Views: 8069
|
|
|
Front HardPoint 2
Date: 12/27/2013
Views: 9668
|
|
