|
|
Emergency Maneuver that starts with Heim? 3 of 13
Date: 12/16/2013
Views: 7745
|
|
|
Two forward and one aft 11/16 nuts get weight reduction
Date: 12/16/2013
Views: 7854
|
|
|
|
Coupler dimensions
Date: 12/16/2013
Views: 9519
|
|
|
I bored this 5/8" Stainless Lock Washers to .785", 11/16" is a wierd size that McMaster didn't offer
Date: 12/16/2013
Views: 8677
|
|
|
|
Clevis Fork dimensions after material removal
Date: 12/16/2013
Views: 8626
|
|
|
Heims overall length cut down to 1.700"
Date: 12/16/2013
Views: 7912
|
|
|
|
Emergency Maneuver that starts with Heim? 1 of 13
Date: 12/16/2013
Views: 8934
|
|
|
Emergency Maneuver that starts with Heim? 2 of 13
Date: 12/16/2013
Views: 9587
|
|
|
|
Front threaded rod cut down to .450 (I aim for minimum of 9.5 threads of engagement on any 5/16-24 joint)
Date: 12/13/2013
Views: 8062
|
|
|
Rod end clevis fork ground down to 1.975" (again minimum 9.5 threads of engagement)
Date: 12/13/2013
Views: 9514
|
|
|
|
Length of coupler is ~ .855" cut down from 1". 9.5 times two is 19, so this allows minimum of 19 threads of engagement
Date: 12/13/2013
Views: 6958
|
|
|
Temporary mount using 1 flat head 1/4-28
Date: 12/13/2013
Views: 7992
|
|
|
|
The threaded portion of my "thunk" fits nicely inside this spacer
Date: 12/13/2013
Views: 10595
|
|
|
The 11/16-16 thread is not too common
Date: 12/13/2013
Views: 7023
|
|
|
|
I will leave ~ 1.25 diameters of thread engaging and remove all else
Date: 12/13/2013
Views: 8047
|
|
|
What an idiot, I turned off half the nut down to spacer OD to save a little weight
Date: 12/13/2013
Views: 7457
|
|
|
|
You can see I left a little space so the spacer can pinch the bearing when the nut is tightened
Date: 12/13/2013
Views: 7472
|
|
|
I'm going to Redux the nut in place and Redux/Flox the thread extender hang-over
Date: 12/13/2013
Views: 7097
|
|
|
|
1/2" ball end-mill on order (McMaster) to to mill a pocket in the brake master cylinder directly above the mounting holes
Date: 12/13/2013
Views: 8985
|
|
|
Using fore and aft the supplied by Europa for push-rod jam nuts that are .155" thick
Date: 12/13/2013
Views: 7285
|
|
