|
|
1/2" clamps that allow cable to slide 2 of 2
Date: 12/16/2013
Views: 10197
|
|
|
Action of Front Cable Mount mov.
Date: 12/13/2013
Views: 5693
|
|
|
|
The magic number is 1.990" from the forward pillow block bearing to the grove.
Date: 12/13/2013
Views: 9227
|
|
|
Cut down Heims to 1.700"
Date: 12/13/2013
Views: 6734
|
|
|
|
I bored this 5/8" Stainless Lock Washers to .785", 11/16" is a wierd size that McMaster didn't offer
Date: 12/16/2013
Views: 8174
|
|
|
Temporary mount using 1 flat head 1/4-28
Date: 12/13/2013
Views: 7499
|
|
|
|
I'm going to Redux the nut in place and Redux/Flox the thread extender hang-over
Date: 12/13/2013
Views: 6653
|
|
|
Checking Flap Throw 1
Date: 12/12/2013
Views: 7320
|
|
|
|
Cable Happy in Spar Tunnel 2
Date: 12/12/2013
Views: 8431
|
|
|
1/2" clamps that allow cable to slide 1 of 2
Date: 12/16/2013
Views: 9048
|
|
|
|
Emergency Maneuver that starts with Heim? 4 of 13
Date: 12/16/2013
Views: 8325
|
|
|
Using fore and aft the supplied by Europa for push-rod jam nuts that are .155" thick
Date: 12/13/2013
Views: 6848
|
|
|
|
A shot to show where the threads end
Date: 12/16/2013
Views: 7152
|
|
|
Emergency Maneuver that starts with Heim? 10 of 13
Date: 12/16/2013
Views: 7814
|
|
|
|
1/2" ball end-mill on order (McMaster) to to mill a pocket in the brake master cylinder directly above the mounting holes
Date: 12/13/2013
Views: 8449
|
|
|
Cable Happy near Fuel Selector and below Air-Brake Cable 1
Date: 12/12/2013
Views: 8290
|
|
|
|
Front Cable Mount with Lever in Up Position
Date: 12/12/2013
Views: 7871
|
|
|
Emergency Maneuver that starts with Heim? 2 of 13
Date: 12/16/2013
Views: 9061
|
|
|
|
I failed a bearing on purpose
Date: 11/27/2013
Views: 14853
|
|
|
Series 6 Push-Pull cable Weight and Length
Date: 12/16/2013
Views: 9549
|
|
