Ipad 039

Concrete base for 20ft x 10ft shed

IMG_0410

IMG_0245

Wife not happy. Aircraft parts in the house!

IMG_0228

Andy & I having a good breakfast prior to the start of our trip to South Wales

IMG_0229

At Steve's workshop packing the kit ready for transportation

DSC00153

Lathe installed

IMG_0187[1]

Started to fit fixtures and fittings

DSC00157

Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.

Ipad 041

Shed Under construction

IMG_0414

DSC00155

As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.

DSC00228

Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the

DSC00165

Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.

IMG_0821

Trial fitted the torque tube but it looks like the TP38 bearing is too short!

IMG_0230

IMG_0344[1]

Aircraft parts & Documents stored

IMG_0340[1]

cloth cabinet installed.

IMG_0412

IMG_0408

DSC00212

Marking position for bracket on rear bulk head