|
|
DSCN6111Ann
Date: 06/13/2007
Views: 4744
|
|
|
IMG_1193ann
Date: 05/31/2010
Views: 4812
|
|
|
|
DSCN6093Ann
Date: 06/12/2007
Views: 6149
|
|
|
IMG_6788post
Length of the cross I-beam
Date: 12/10/2009
Views: 4945
|
|
|
|
1_Door_Knobs
The new door knob mounting hardware is a stainless steel "binding post" acquired from McMaster-Carr. These things are available in myriad materials and sizes. There just happened to be a perfect size in the stainless steel variety which I pref
Date: 06/23/2011
Views: 6675
|
|
|
IMG_7270post
Date: 02/21/2010
Views: 5276
|
|
|
|
IMG_6702Ann
Date: 02/15/2008
Views: 6931
|
|
|
InsideClosed
Date: 07/09/2003
Views: 9149
|
|
|
|
6_snaps
Seat cushions installed and snapped into place.
Date: 06/23/2011
Views: 7109
|
|
|
Plexi01small
Date: 04/04/2005
Views: 4710
|
|
|
|
DSCN6167Ann
Date: 06/24/2007
Views: 5338
|
|
|
Intercooler05
Date: 01/07/2006
Views: 7083
|
|
|
|
IMG_1167ann
Went to the hanger after work and put the brake back together. Seems to work fine. I have not safety wired it yet as I want to add fluid, bleed and give it a good test beforehand. When all tests wel,l with no leaks, I'll wire it up. Could have used a
Date: 04/19/2010
Views: 4604
|
|
|
IMG_7559ann
This is the Billet regulator with the two new adaptors. When I return from India, I shall get back to work on both the brake modifications and the installation of the Billet pump and regulator.
Date: 04/30/2010
Views: 6408
|
|
|
|
IMG_7541ann
It took almost an hour to carefully and safely get the tap started in the aluminum brake. I sure didn't want to screw that up. Once I had a good start and the tap began to cut, I clamped the tap in the vice with the brake held high so chips fall out and
Date: 04/18/2010
Views: 4585
|
|
|
IMG_6973post
Pointing out areas relieved for fit over swing arm
Date: 12/27/2009
Views: 4793
|
|
|
|
DSCN5015Ann
Date: 12/08/2006
Views: 7370
|
|
|
DSCN6122Ann
Date: 06/14/2007
Views: 4667
|
|
|
|
IMG_1215ann
Date: 06/13/2010
Views: 5157
|
|
|
Intercooler06
Date: 01/07/2006
Views: 6629
|
|
