Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 17864
Ceiling panel layout begins
Date: 03/05/2009
Views: 3298
IMG_0059
Date: 05/03/2007
Views: 3575
Newest Image
EAA SITE
Date: 08/23/2023
Views: 144257
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 549655
Front fuse conduit run 36.
These two #4 flat head Torx trilobal 1/4" long screws are holding a clamp in place on the bottom side of the thigh support that is holding a HD 15 pin D-sub connector in place that allows stick removal.
This is the port side, the starboard side has one also.
Y10-12-12