|
DSCN0033
Date: 10/10/2009
Views: 3104
|
|
|
DSCN0034
Date: 10/10/2009
Views: 2771
|
|
|
Supplied nuts are too thick for the thin side of the tang 2.
Date: 10/14/2009
Views: 2860
|
|
|
Port aft hinge mounted as well.
Date: 10/15/2009
Views: 3031
|
|
|
This is the gap at high point on port door.
Date: 10/15/2009
Views: 2862
|
|
|
Mounted top port front hinge.
Date: 10/15/2009
Views: 2661
|
|
|
Token counterbore.
Date: 10/14/2009
Views: 2660
|
|
|
Port front spacer perfectly bonded in position.
Date: 10/14/2009
Views: 3491
|
|
|
Port aft spacer perfectly bonded.
Date: 10/14/2009
Views: 2665
|
|
|
4 nuts sanded down to .125"
Date: 10/14/2009
Views: 2879
|
|
|
Supplied nuts are too thick for the thin side of the tang 1.
Date: 10/14/2009
Views: 2357
|
|
|
Nice fit.
Date: 10/14/2009
Views: 2665
|
|
|
Used a 1/8" piloted 100 degree counterbore to counterbore hinges.
Date: 10/14/2009
Views: 3080
|
|
|
Used these tools to measure gap.
Date: 10/14/2009
Views: 3078
|
|
|
Bonding port front spacer to fuse with JB KWIK weld.
Date: 10/12/2009
Views: 2900
|
|
|
Bonding port aft spacer to fuse with JB KWIK weld.
Date: 10/12/2009
Views: 3302
|
|
|
Trimmed tang overhang inboard of the inboard edge of hinge leaving thickness of tang plus 10%.
Date: 10/12/2009
Views: 2910
|
|
|
Once door is removed will countersink top half of hinge.
Date: 10/12/2009
Views: 3006
|
|
|
Port aft spacer is thinner than front.
Date: 10/12/2009
Views: 2836
|
|
|
Used the 1/4-20 bondable stud in drill press to proper position door.
Date: 10/12/2009
Views: 3847
|
|