Trying not to mar flap cross tube too bad with Upstops 7 of 7

I kinda think the .500" long screw assemblies are gonna be just about right, but made up a set of .750" just in case.

I suppose I could have just made a .750" long set, then if I found out it was too long could have cut it down to size, then used a hacksaw to slot the screw (since I would have cut off the Allen portion). A little paranoid though, because if for whatever reason the threads galled, you may not be able to remove with a hacksaw slot and screwdriver. I was just barely able to remove with a large Allen wrench when things galled up when I was fooling with stop nut.

Y13-12-26