|
|
dsc08601
Just a shot of the plane at home.
Date: 04/10/2012
Views: 28316
|
|
|
dsc08608
These will have to go. They are on top and I will remove them and put one vent on the bottom.
Date: 04/10/2012
Views: 37141
|
|
|
|
DSC08796
Put in the panel to dream a little. Don't really know what I'm going to do. Was thinking of keeping it low cost for the first panel and keeping it analog until I can get the cash mula for something better like glass/IFR. Also want to fill the hole where
Date: 06/05/2012
Views: 98295
|
|
|
dsc08600
Thinking of modifying the mono wheel trailer as a jig to perform the tri-gear conversion.
Date: 04/10/2012
Views: 40156
|
|
|
|
dsc08616
Same here, rust needs to go! Open to ideas.....
Date: 04/10/2012
Views: 20898
|
|
|
dsc08605
When I received the plane it had a few areas of this green tape. I guess it was going to be used as a release agent for some sort of jig fabrication. I have found that this 3M stuff works very well.
Date: 04/10/2012
Views: 32519
|
|
|
|
dsc08609
Underside of vents.
Date: 04/10/2012
Views: 37660
|
|
|
dsc08613
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 30948
|
|
|
|
dsc08614
Anybody know a easy way to remove this rust?
Date: 04/10/2012
Views: 29910
|
|
|
dsc08612
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 33990
|
|
|
|
dsc08603
Since I'm going to have to remove the mono wheel I dont have much of an edge to close in the big hole in the bottom. I'll have a better look at it once its a tri-gear.
Date: 04/10/2012
Views: 30569
|
|
|
dsc08611
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 39922
|
|
