Starboard door fit, there are 2 clamps on hinge tangs holding door in place.
Date: 10/20/2009
Views: 2864
Newest Image
EAA SITE
Date: 08/23/2023
Views: 122680
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 543204
IMG_6409
The duct needs to be considerably further back than I thought. That is what you get when the manual shows a grainy photo with the caption "approximate position of cooling duct" with an obsolete muffler, which gives you no guidance at all. Anyway, this is the new position. Should have measured the coordinates for posterity but now it's in I am durn well not going to take it out again. Use eyeball instead.
Another problem is that the space between the footwells recedes and getting the ducting even a few cm further back is impossible. I dont't want to disassemble the duct to trim it so resort to the inelegant solution of sanding the footwells slightly. Looks worse than it is. But be warned- trim the back end of the CD 1 a few mm before riveting on CD 2 and 3.