Ron and Alan took turns working on starboard bracket.
Date: 01/20/2010
Views: 3439
First pass of Port top wingskin bond on 16.
Date: 09/11/2010
Views: 2487
dscn0042
Date: 12/31/1969
Views: 3014
Newest Image
EAA SITE
Date: 08/23/2023
Views: 96509
DSCN5428
Inboard of worst area is dug out where needed.
Green tape depicts where structural glass reinforcement is needed because glass that was removed was never laminated to lower layers.
Thus far plan is:
**Repair worst areas with a total of 3 plies of 3" wide thin model aeroplane cloth (3.2 oz) scuff sanded down to glass.
**Fill any voids on rest of lead edge with flox, then lay up 1 ply of thin model aeroplane cloth (hope to stabalize to prevent future cracking in gel coat) only scuff gelcoat.
**When above layup gets thick and tacky, will fill with Aeropoxy light filler wet on wet.
**Will use my Vitrex 1030 autobody profile tool and try and reproduce factory shaped lead edge using yet untouched port wing as a guide.
Y9-07-19