|
|
Mass_Balance_Tower_22
Date: 01/23/2006
Views: 3426
|
|
|
Option B) Electrical Box install 5 of 5.
Date: 08/12/2003
Views: 7458
|
|
|
|
Jim Brown 4.
Date: 01/05/2011
Views: 6267
|
|
|
63_fuelpickup
Date: 12/31/1969
Views: 4544
|
|
|
|
IMGA0728
Date: 07/14/2015
Views: 92443
|
|
|
Here is my informational sign used at car show.
Date: 02/16/2010
Views: 6815
|
|
|
|
CH6_3
Date: 12/31/1969
Views: 6471
|
|
|
CBM - 36 - HARNESS
Date: 11/18/2013
Views: 3206
|
|
|
|
dscn1801
Date: 12/31/1969
Views: 3621
|
|
|
imm022_23A
Date: 09/03/2009
Views: 5177
|
|
|
|
030502_inst_panel_started
Date: 12/31/1969
Views: 3499
|
|
|
Engine sensor location and wiring information
Date: 07/31/2011
Views: 6020
|
|
|
|
IMG_1304
Inside fitting
Date: 04/14/2011
Views: 5234
|
|
|
nex_2014_01_25_05
My lovely bride helping us out. Notice the jig is the mono wheel trailer.
Date: 01/25/2014
Views: 19407
|
|
|
|
dsc08640
OK not the best shot but here you can see I used the jack to move the rear rib in place under the airframe being careful not to pinch the belly. I then secured the rib in place but using some drywall screws in the 2x6. This way any weight will be transf
Date: 04/15/2012
Views: 23220
|
|
|
Vertical upright, swing-arm and generator install 7 of 7.
Date: 08/06/2003
Views: 7205
|
|
|
|
10122002182041_G
Date: 12/31/1969
Views: 3503
|
|
|
dsc09018
Started to make the axle jig. Used a simple setup of first taking large flat blocks of wood and caulking it to the floor somewhere over FS70. Then that allows me to fix the aluminum angle with a single screw once in its final position.
Date: 01/10/2013
Views: 20667
|
|
|
|
dsc08627
The monowheel landing gear is in the up position and resting on the main wheel with some of the weight held by the block and tackle. This was taken just before putting on the braces to keep her from rolling. Been trying to get rid of that tv in the back
Date: 04/14/2012
Views: 29061
|
|
|
Wiring01
Date: 02/04/2004
Views: 3808
|
|
