|
|
IMG_2082
Date: 12/01/2004
Views: 7291
|
|
|
06032003230754_G
Date: 12/31/1969
Views: 4213
|
|
|
|
Mass balance bumper.
Date: 05/05/2009
Views: 5628
|
|
|
Baggage_Area_18
Date: 06/03/2007
Views: 6540
|
|
|
|
Pre-made harness 7.
Date: 03/26/2009
Views: 6969
|
|
|
IMG_5729ann
Date: 10/21/2007
Views: 4565
|
|
|
|
Baggage_Area_12
Date: 01/22/2006
Views: 7906
|
|
|
Intercooler08
Date: 01/07/2006
Views: 6885
|
|
|
|
2006SnF001
Date: 04/07/2006
Views: 11291
|
|
|
New MC-4A 03
2012004 15 - In order to get the new MC-4A's to fit within the available space, the threaded end has to be shortened so that when the attach fitting is screwed on fully, there will be not threaded end protruding into the attach fitting. Removing this muc
Date: 04/12/2012
Views: 4973
|
|
|
|
Front fuse conduit run 15.
Date: 09/09/2010
Views: 7725
|
|
|
dscn0316
Date: 12/31/1969
Views: 4123
|
|
|
|
IMG_0003
Date: 03/19/2005
Views: 6147
|
|
|
Aft sill cover 12.
Date: 08/31/2010
Views: 7087
|
|
|
|
Pre-made harness 9.
Date: 03/26/2009
Views: 7033
|
|
|
Fitting_Wings_12
Date: 06/07/2007
Views: 6652
|
|
|
|
MG_2915
Date: 03/17/2008
Views: 4816
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 68810
|
|
|
|
JB KWIK aileron dam 2.
Date: 09/27/2010
Views: 6783
|
|
|
Fin cap conduit 1.
Date: 05/07/2009
Views: 11118
|
|
