|
|
IMG_1412
Another issue with the pre-built cockpit module. The fuel tank was not supported on the aluminum angle. Bud suggested this could cause tank cracking and recommended some sort of support be added. I cut a wedge from a length of balsa and covered it with
Date: 05/28/2011
Views: 5775
|
|
|
IMG_2439
Date: 12/11/2005
Views: 5702
|
|
|
|
Xponder00Ann
Date: 04/22/2004
Views: 3420
|
|
|
Wings_Trial_Fitting_No2
Date: 09/03/2004
Views: 7911
|
|
|
|
Archer_6_antenna_install_16
Date: 01/23/2009
Views: 6449
|
|
|
IMG_1416
End of May. Applied primer to all the repaired and patched areas. Port wing outboard flap bracket area.
Date: 05/31/2011
Views: 6116
|
|
|
|
Port wing 1.
Date: 09/14/2009
Views: 6014
|
|
|
Fuse seam 1.
Date: 04/02/2009
Views: 8065
|
|
|
|
TailWheelMount24Ann
Date: 08/19/2004
Views: 3436
|
|
|
Fuel_System_15_003
Date: 05/19/2008
Views: 4809
|
|
|
|
MG_2937
Date: 03/17/2008
Views: 4437
|
|
|
Strobererer_8
Date: 05/18/2009
Views: 5575
|
|
|
|
IMG_7753Ann
Date: 06/13/2008
Views: 4327
|
|
|
Panel_02
Date: 01/23/2006
Views: 4619
|
|
|
|
IMG_6635post
Date: 09/26/2009
Views: 4999
|
|
|
IMG_6541Ann
Date: 01/11/2008
Views: 4909
|
|
|
|
IMG_8738post
Date: 08/10/2009
Views: 7119
|
|
|
GJ7I2406
Date: 07/09/2006
Views: 4482
|
|
|
|
Making awful fit of lift pads correct 11.
Date: 10/12/2010
Views: 5682
|
|
|
DSCN5302Ann
Date: 12/21/2006
Views: 4653
|
|
