|
|
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 31781
|
|
|
TailWheelMount12
Date: 02/02/2004
Views: 4828
|
|
|
|
ramp_cable_attachment
Date: 04/02/2006
Views: 9058
|
|
|
DSC00073
Date: 12/31/1969
Views: 7688
|
|
|
|
DSCN4367
Date: 03/26/2009
Views: 9261
|
|
|
Fin cap 26.
Date: 03/21/2009
Views: 8774
|
|
|
|
P8310067
Date: 08/31/2007
Views: 9149
|
|
|
InstrumentPanel31Ann
Date: 05/27/2004
Views: 4449
|
|
|
|
DSCN8345
Date: 09/19/2010
Views: 6122
|
|
|
Nose 3.
Date: 04/01/2009
Views: 9175
|
|
|
|
IM003631
Date: 11/24/2007
Views: 7374
|
|
|
Autopilot_22
Date: 05/19/2008
Views: 5605
|
|
|
|
Control_Systems_17
Date: 01/23/2006
Views: 4818
|
|
|
IM001690
Date: 10/29/2007
Views: 9040
|
|
|
|
IMG_2884Ann
Date: 12/20/2008
Views: 5392
|
|
|
L1010172
Date: 03/17/2008
Views: 6129
|
|
|
|
IMG_3218
Once the brakes seemed to be OK it was time to run the engine and check it out. That didn't go well. Started well, warmed up with a bit of choke at the beginning. Smoothed out nicely and idled properly after it was all warmed up. Then I added throttle
Date: 05/18/2012
Views: 7366
|
|
|
IMG_0760
Date: 11/11/2005
Views: 5753
|
|
|
|
IMG_0024
Date: 07/18/2007
Views: 5845
|
|
|
IMG_7983Ann
Date: 06/29/2008
Views: 7382
|
|
