|
|
Drawer closer 6.
Date: 08/17/2010
Views: 5709
|
|
|
IMG_7767
The sight gage with calibration markers.
Date: 05/18/2014
Views: 7664
|
|
|
|
IMG_1119
Date: 03/19/2004
Views: 5008
|
|
|
IMGA0581
Date: 03/18/2013
Views: 82335
|
|
|
|
IMG_1405
Put the stabs back on and check them out and checked out the trim for operation. All OK.
Date: 05/27/2011
Views: 5290
|
|
|
IMG_0256
Date: 07/03/2005
Views: 4531
|
|
|
|
DSCN4404Ann
Date: 06/10/2006
Views: 3465
|
|
|
TrimRelayDeck13Ann
Date: 04/21/2005
Views: 4120
|
|
|
|
IMG_3274
Date: 11/18/2016
Views: 40363
|
|
|
IMG_5873post
Date: 08/09/2009
Views: 4583
|
|
|
|
139_3907
Date: 12/31/1969
Views: 5734
|
|
|
Look Ma, no hatches!
Date: 07/01/2017
Views: 14583
|
|
|
|
IMG_0751
Date: 11/07/2005
Views: 5199
|
|
|
The 11/16-16 thread is not too common
Date: 12/13/2013
Views: 5151
|
|
|
|
IMG_7441post
Here's a look at the tubing end of the two fittings. Again, similar, but not the same. Can't use the original fitting with the new tubing.
Date: 03/19/2010
Views: 3885
|
|
|
Fred fitting fairings 6.
Date: 02/14/2009
Views: 4885
|
|
|
|
DSC00214
Date: 04/10/2009
Views: 5031
|
|
|
IMG_3265
Herein lies the culprit! The change from flat fiber washer to "O" ring. When the "O" ring is applied to the attachment screw and tightened to the torque spec, the bottom of the fuel bowl is deformed upward. This deformation reduces
Date: 05/30/2012
Views: 28440
|
|
|
|
IMG_1532
Date: 05/26/2004
Views: 3899
|
|
|
IMG_6643post
Date: 09/26/2009
Views: 4316
|
|
