|
Nose 16.
Date: 04/02/2009
Views: 5182
|
|
|
IMG_6976
At this point all that's left is that portion of the tank which was bonded to the back of the back rest.
Date: 10/19/2013
Views: 4221
|
|
|
Port mass balance 3.
Date: 09/17/2009
Views: 2414
|
|
|
IMG_1412
Another issue with the pre-built cockpit module. The fuel tank was not supported on the aluminum angle. Bud suggested this could cause tank cracking and recommended some sort of support be added. I cut a wedge from a length of balsa and covered it with
Date: 05/28/2011
Views: 3024
|
|
|
CH17_34
Date: 12/31/1969
Views: 2866
|
|
|
MG_2978
Date: 03/17/2008
Views: 3056
|
|
|
12122010508
Date: 12/12/2010
Views: 5257
|
|
|
IMG_0686
Date: 10/28/2005
Views: 4018
|
|
|
DSCN6195Ann
Date: 07/01/2007
Views: 3853
|
|
|
IMG_8089Ann
Date: 07/08/2008
Views: 3260
|
|
|
IMG_2330
Date: 07/10/2005
Views: 3005
|
|
|
DSCN4977Ann
Date: 12/04/2006
Views: 2828
|
|
|
DoorRearLatchLights08Ann
Date: 08/27/2005
Views: 2313
|
|
|
dscn2745
Date: 12/31/1969
Views: 2205
|
|
|
DSCN3224
Date: 12/31/1969
Views: 2832
|
|
|
DoorLatch58Ann
Date: 05/11/2004
Views: 2123
|
|
|
nex_2014_01_25_03
Port side dirty work. Just test fitting final install with all hardware will be after the legs are painted.
Date: 01/25/2014
Views: 6750
|
|
|
DSCN5292Ann
Date: 12/21/2006
Views: 2757
|
|
|
Going to add a 6 position switch.
Date: 02/16/2010
Views: 5208
|
|
|
Inspection_cover_and_rudder_fairlead_and_crack_Y9_06_07
Date: 06/07/2009
Views: 2461
|
|