|
|
IMG_2074
Date: 12/01/2004
Views: 6910
|
|
|
N9855S
Date: 10/08/2004
Views: 5447
|
|
|
|
IMG_0310Ann
Date: 05/18/2008
Views: 5313
|
|
|
Landing_Gear_46
Date: 01/23/2006
Views: 7189
|
|
|
|
Pre-made harness 2.
Date: 03/26/2009
Views: 6400
|
|
|
Fuel_system_17
Date: 07/01/2007
Views: 6371
|
|
|
|
IMG_0138
Date: 07/03/2005
Views: 6369
|
|
|
IMG_2456
Drilling for the rivets to hold the anchor nuts required novel technique. Eventually, all anchor nuts were installed.
Date: 10/25/2011
Views: 7091
|
|
|
|
DSCN6163Ann
Date: 06/24/2007
Views: 5797
|
|
|
dscn0861
Date: 12/31/1969
Views: 4655
|
|
|
|
DSCN5432Ann
Date: 12/31/2006
Views: 6362
|
|
|
LGLever08
Date: 02/09/2004
Views: 4181
|
|
|
|
IMG_3571em_r
Pulled all the pressure hose off again and check for leaks and continuity. All OK, no problems at all.
Date: 08/01/2012
Views: 9111
|
|
|
Control_Systems_65_19
Date: 06/03/2007
Views: 4886
|
|
|
|
Clevis Fork dimensions after material removal
Date: 12/16/2013
Views: 8411
|
|
|
DSCF0008_001
Date: 08/03/2009
Views: 4672
|
|
|
|
73_fueltank
Date: 12/31/1969
Views: 4920
|
|
|
IMG_1412
Another issue with the pre-built cockpit module. The fuel tank was not supported on the aluminum angle. Bud suggested this could cause tank cracking and recommended some sort of support be added. I cut a wedge from a length of balsa and covered it with
Date: 05/28/2011
Views: 6120
|
|
|
|
DSCF0025
Date: 06/19/2009
Views: 6587
|
|
|
Bb2
Date: 02/01/2009
Views: 5671
|
|
