|
|
Fuel_system_02
Date: 07/01/2007
Views: 5284
|
|
|
GJ7I2427
Date: 07/09/2006
Views: 5251
|
|
|
|
25092002172644_G
Date: 12/31/1969
Views: 4350
|
|
|
Control_Systems_65_6
Date: 06/03/2007
Views: 5196
|
|
|
|
IMG_3391em
Input fuel pressure: 5 lbs. Just like with the Billet pump. Next request was for a fuel flow test. Reconnected the Billet pump to the fuel circult. One electric pump running fuel through the billet pump produced 1 gallon of fuel in a bit less than 3 m
Date: 07/09/2012
Views: 9866
|
|
|
MR2510 button housing diodes
Date: 06/14/2010
Views: 7461
|
|
|
|
Gearbox tear down 4
Date: 08/19/2010
Views: 3754
|
|
|
IMG_7540ann
That leaves two choices: #1 - tap the brake in BSPP threads or #2 - run the BSPT die over the bolt to thread in BSPT. The brake being aluminum and the bolt being stainless steel, I decided to go with #1 as it seemed easier.
Date: 04/18/2010
Views: 4824
|
|
|
|
Buss_bar
Date: 12/17/2008
Views: 6244
|
|
|
DSCN4386Ann
Date: 05/28/2006
Views: 5817
|
|
|
|
02052008050_G
Date: 10/14/2009
Views: 7341
|
|
|
42aileron_work2
Date: 12/31/1969
Views: 3587
|
|
|
|
2012-08-18_19-58-42_666
Port side. Same area as before just without the flash. Backlit from the inside to show areas with less material. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 23021
|
|
|
Supplied nuts are too thick for the thin side of the tang 2.
Date: 10/14/2009
Views: 5229
|
|
|
|
dscn0279
Date: 12/31/1969
Views: 4044
|
|
|
DSCN6140
Date: 10/11/2009
Views: 5540
|
|
|
|
DSCN5008Ann
Date: 12/08/2006
Views: 4260
|
|
|
24_04_08_vliegfoto_s_097
Date: 04/26/2008
Views: 4435
|
|
|
|
rudder_2
Date: 11/18/2013
Views: 5949
|
|
|
BondStbdTail01Ann
Date: 06/23/2004
Views: 3879
|
|
