|
|
IMG_7429post
Here's a closeup of the hose end, bolt and washers. The hose end connector is identical to that which was on the master cylinder end so this should easily replace the 90 degree AN hose end provided. We'll know better later this week when I can get to th
Date: 03/15/2010
Views: 4555
|
|
|
Alternate use of tailwheel clip.
Date: 10/23/2010
Views: 8036
|
|
|
|
Anti door warping 2.
Date: 11/16/2009
Views: 5676
|
|
|
Flowscan wire run 4.
Date: 08/04/2010
Views: 5824
|
|
|
|
TrimWiring03Ann
Date: 05/27/2004
Views: 4516
|
|
|
Cable Happy near Fuel Selector and below Air-Brake Cable 2
Date: 12/12/2013
Views: 7728
|
|
|
|
IMG_0297
Date: 04/16/2005
Views: 4459
|
|
|
Flap drive pin install 3.
Date: 11/30/2010
Views: 6991
|
|
|
|
DSC01503_Texted
Date: 12/31/1969
Views: 5750
|
|
|
DSC00873
Date: 04/15/2005
Views: 5185
|
|
|
|
Tailwheelmount
Date: 02/12/2004
Views: 4831
|
|
|
DSCN4655Ann
Date: 08/20/2006
Views: 7185
|
|
|
|
IMGA0662
Date: 01/28/2015
Views: 134846
|
|
|
DSCN6694
Date: 10/25/2009
Views: 5813
|
|
|
|
031802_door
Date: 12/31/1969
Views: 4637
|
|
|
IMG_2685
I elected to make up a support structure from some 12" 1 1/2 x 1 1/2 wide aluminum angle i had in my aluminum bin. Cut two lengths 5 1/2" long and clamped them to the base well centered and drilled out holes matching the base. Attached them t
Date: 04/09/2012
Views: 4888
|
|
|
|
L1010191
Date: 03/17/2008
Views: 7178
|
|
|
DSC_0037
Date: 08/31/2007
Views: 6415
|
|
|
|
Vertical upright, swing-arm and generator install 1 of 7.
Date: 08/12/2003
Views: 8839
|
|
|
Photo_052007_003
Date: 05/20/2007
Views: 4034
|
|
