If Factory location does not work well for AOA, will just make hole in this wing cover and 2 BID back of cover with probe washer at proper angle, (2 BID should be weak enough to break in case of trauma instead of wing or cover?), TIG 2 stainless studs, (cut off head of screw), to probe washer and screw onto BID with nuts and washers, then fill probe washer with Redux/Q-Cel so as to be flush with cover and removable. Not done yet though, once clamp is removed will fill with area with Aeropoxy Light and level so will be ready for paint, (probably fill/sand twice, rare one pass does it).
Y7-12-02
