Ron and Alan took turns working on starboard bracket.
Date: 01/20/2010
Views: 6461
First pass of Port top wingskin bond on 16.
Date: 09/11/2010
Views: 5593
dscn0042
Date: 12/31/1969
Views: 4504
Newest Image
EAA SITE
Date: 08/23/2023
Views: 693545
Most Viewed Image
EAA SITE
Date: 08/23/2023
Views: 693545
Pep_boys_10
If you were to put 12 volts to LED direct you would most likely burn the LED out instantly. The supplied harness has a regulator to drop voltage. Chuck Rhoads (a Europa owner) has J.C. Whitney LEDs installed and has problem with noise when transmitting. I did a quick test on Pepboys LED putting my Vertex VXA-700 near this regulator and BINGO, it's noisy. Of course we also tested running on supplied Lithium battery and things were dead silent. Since there was a wad of aluminium foil in the trash (left over from chasing strobe noise) and wrapped the entire harness, no change at all.
Ira mentioned:
"LED high intensity elements are often pulsed to achieve higher output within thermal constraints hence RFI" so it is possible that is what they are doing.
Y9-02-21
