Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 17603
Ceiling panel layout begins
Date: 03/05/2009
Views: 3167
IMG_0059
Date: 05/03/2007
Views: 3425
Newest Image
EAA SITE
Date: 08/23/2023
Views: 118062
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 542080
DSCN6012Ann
I flew the Super Decathalon for 1.2 hrs today. It went extremely well. Using the definitions: Good Landing - any landing you can walk away from & Excellent Landing - any landing where you can use the aircraft again. I managed 6 excellent landings. None of them were very pretty, but I didn't break anything. I'll be doing 1 to 1.5 hours every Friday until I can make those "excellent" landings pretty as well.