We JB KWIKed in place the shimming washers and the hardened Belleville like cone shaped washer with a G-10 washer on the outside figuring we would just fill between the G-10 washer and the cockpit module.
When Alan was cleaning up preparing for final bonding, the G-10 washer delaminated a little.
I decided to pull off the G-10 washer and 2 BID over the whole lot.
In order to keep the center of the forward most washer clear so the spar pin can rest on it, we JB KWIKed a socket in place that was covered in 3M 375 packaging tape.
We also used the G-10 washer that was taped to keep the 2 BID laying nice and flat in the center.
Y10-11-09
