Trying not to mar flap cross tube too bad with Upstops 1 of 7
Date: 12/26/2013
Views: 6502
FWF_3
Date: 07/01/2007
Views: 3907
IMG_3331em
Date: 06/12/2012
Views: 3101
Newest Image
EAA SITE
Date: 08/23/2023
Views: 94373
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 535113
IM003498
Not a great shot, the hole on top of stabilator for shoulder screw is not cleaned up but is a machined piece that allows proper seal for shoulder screw. Notice 2 seals on screw, guess you can't easily tell but there are 2. No drain needed. The top of screw is perfect flush with stabilator and need a allen wrench to remove. In the very unlikely chance that at the same time the 2 seals ever got loose, we have a small Delrin round nosed plunger that falls into groove on shoulder screw. Figure if ya r gonna do it, do it right. Since on the subject of ball plungers, I added one to the T Bar to keep viabration from banging it back and fourth, holds things nice. Sorry no pic. Green is glass/Redux that is holding foam and recess in place.