|
dsc08614
Anybody know a easy way to remove this rust?
Date: 04/10/2012
Views: 8777
|
|
|
dsc08627
The monowheel landing gear is in the up position and resting on the main wheel with some of the weight held by the block and tackle. This was taken just before putting on the braces to keep her from rolling. Been trying to get rid of that tv in the back
Date: 04/14/2012
Views: 8705
|
|
|
dsc08606
Old mass balance arm.
Date: 04/10/2012
Views: 8659
|
|
|
p1000617
p1000617.jpg
Date: 01/29/2012
Views: 8635
|
|
|
p1000699
p1000699.jpg
Date: 03/12/2012
Views: 8630
|
|
|
dsc08965
Port side after layups and peel ply removed. Notice shape of hole for the angle of the LG socket. I wrapped the LG socket with sandpaper and used it to form the hole.
Date: 10/01/2012
Views: 8607
|
|
|
p1000615
p1000615.jpg
Date: 01/29/2012
Views: 8595
|
|
|
dsc08403
Bill helping me out!
Date: 03/25/2012
Views: 8542
|
|
|
DSC08800
starboard side
Date: 06/05/2012
Views: 8525
|
|
|
DSC08797
Port side
Date: 06/05/2012
Views: 8481
|
|
|
p1000616
p1000616.jpg
Date: 01/29/2012
Views: 8478
|
|
|
dsc08967
Little clean up required on Port side.
Date: 10/01/2012
Views: 8466
|
|
|
dsc08399
Atempting to remove the mass ballance brace but to only find out later that it is bonded at the top.
Date: 03/25/2012
Views: 8459
|
|
|
DSC08801
starboard side
Date: 06/05/2012
Views: 8456
|
|
|
p1000700
p1000700.jpg
Date: 03/12/2012
Views: 8302
|
|
|
DSC08799
Port side
Date: 06/05/2012
Views: 8288
|
|
|
dsc08400
Very hard to work in the tunnel and I'm a small guy, 5'11“ 150#
Date: 03/25/2012
Views: 8184
|
|
|
dsc09018
Started to make the axle jig. Used a simple setup of first taking large flat blocks of wood and caulking it to the floor somewhere over FS70. Then that allows me to fix the aluminum angle with a single screw once in its final position.
Date: 01/10/2013
Views: 8148
|
|
|
dsc08963
Port side. LG socket fitting.
Date: 10/01/2012
Views: 8142
|
|
|
dsc08607
Starting to prep the bays for the tri-gear conversion.
Date: 04/10/2012
Views: 8139
|
|