Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 17249
Ceiling panel layout begins
Date: 03/05/2009
Views: 3069
IMG_0059
Date: 05/03/2007
Views: 3309
Newest Image
EAA SITE
Date: 08/23/2023
Views: 94014
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 535023
IMG_5025
Bonding the antenna to the back of the sternpost. Should have bought an antenna with the connector straight out so I could have put it on the back. Didn't of course, so it now has to go on the angled side. Just fits without interfering with the fin.