|
IMG_1449p
Greatly simplified fuel plumbing, all cleaned up and tied down. Not a particularly good pic. I'll see if I can get a better one.
Date: 06/04/2011
Views: 2279
|
|
|
IMG_0217post
Date: 09/09/2010
Views: 2552
|
|
|
IMG_3277
Here's a better picture of the nitrile gasket in place on the port carb gasket groove.
Date: 05/30/2012
Views: 3622
|
|
|
IMG_0051post
Date: 09/01/2010
Views: 2589
|
|
|
IMG_3577post
Next test, connect high pressure port from airbox directly to the "T" into the carb float bowl pressure lines and try a run. Still didn't work. Same smooth up to 4200/4300 RPM, smooth drop to 3200 RPM, smooth acceleration up to 4300 RPM, drop
Date: 08/03/2012
Views: 7237
|
|
|
IMG_0238post
Date: 09/11/2010
Views: 2284
|
|
|
IMG_3290post
Here you can see where the gasket was cut by the bowl where it wasn't properly located.
Date: 05/31/2012
Views: 3290
|
|
|
IMG_0098post
Date: 09/03/2010
Views: 2538
|
|
|
IMG_1470ann
2011 01 26 January proves to be as cold and nasty as December. Finally have a day to work. Start by aligning the new outer flap brackets to make ready for mounting.
Date: 01/26/2011
Views: 2434
|
|
|
IMG_1284ann
Cut a piece of aluminum for the console cover. Laid out the pattern on the aluminum sheet and traced around it.
Date: 03/30/2011
Views: 2613
|
|
|
IMG_1299
Began the process of making up mounts for the wheel pants.
Date: 04/11/2011
Views: 2430
|
|
|
IMG_0135post
Date: 09/03/2010
Views: 2615
|
|
|
IMG_2604
Got out the inspection mirror and made sure the gasket was in place all the way round the bowl. It was.
Date: 05/30/2012
Views: 4742
|
|
|
IMG_0151post
Date: 09/04/2010
Views: 2512
|
|
|
New MC-4A 04
The MC-4A's must fit within this length and that 3/4" should allow the fit.
Date: 04/15/2012
Views: 2897
|
|
|
3_Door_Knobs
And low profile screw end that won't catch on the door handle guard plate.
Date: 06/23/2011
Views: 2553
|
|
|
IMG_0199post
Date: 09/08/2010
Views: 2356
|
|
|
IMG_2601
I took the float bowl off the starboard carb and removed the old gasket. The instructions with the new nitrile gasket said to apply some grease to hold the gasket in place while the bowl was replaced. I didn't have any grease but I had some light oil wh
Date: 05/30/2012
Views: 2885
|
|
|
IMG_0243post
Date: 09/13/2010
Views: 2252
|
|
|
New MC-4A 08
With the mounting holes drilled and the sides cut away the brackets are attached to the mount.
Date: 04/15/2012
Views: 2564
|
|