|
FL 18 hollow pivot 1
Date: 08/04/2013
Views: 3858
|
|
|
DSCF0614
Date: 07/25/2003
Views: 3425
|
|
|
DSC00094_Texted
Date: 12/31/1969
Views: 3049
|
|
|
Ledd2
Date: 02/01/2009
Views: 3783
|
|
|
Generator harness install 2 of 2.
Date: 08/12/2003
Views: 4770
|
|
|
TrimSwitchesWire03S
Date: 02/27/2005
Views: 2394
|
|
|
108_0834_IMG
Date: 10/21/2003
Views: 3454
|
|
|
Dan Bish's spar guide.
Date: 04/15/2006
Views: 11939
|
|
|
IMG_2081
Date: 12/01/2004
Views: 3138
|
|
|
dsc08642
From the start the airframe was sitting 2.5 deg tail low and 0.1 deg to port. Not bad for just putting her on there. I jacked up the back of the trailer to get it as near to 0.0 as possible and also shifted the airframe latterly to turn that .1 to 0.0 a
Date: 04/15/2012
Views: 9939
|
|
|
Flap drive pin install 6.
Date: 11/30/2010
Views: 3432
|
|
|
DSCF0037
Date: 03/02/2009
Views: 2477
|
|
|
Pretty Slick Dolly by Roger Targett 3
Date: 12/02/2013
Views: 4622
|
|
|
DoorRearLatchLights08Ann
Date: 08/27/2005
Views: 2156
|
|
|
IM003533
Date: 11/06/2007
Views: 4601
|
|
|
022702_nav_lite_tab
Date: 12/31/1969
Views: 2442
|
|
|
rudder_2
Date: 11/18/2013
Views: 1700
|
|
|
34ailron_vaxc_bag_removel
Date: 12/31/1969
Views: 2394
|
|
|
DSCF0726
Date: 08/02/2003
Views: 3361
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 7454
|
|