Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 31101
Ceiling panel layout begins
Date: 03/05/2009
Views: 7056
IMG_0059
Date: 05/03/2007
Views: 5798
Newest Image
EAA SITE
Date: 08/23/2023
Views: 835427
IM000407
Besides some remaining damage and hardware used that can best figure is made up from melted down orange juice cans, fit in many areas << poor at best. Complaining, jumping up and down, yelling and screaming does not get aeroplanes built. Even though trailer was expensive, still figure way ahead compared to start from scratch. About 375$ from McMaster Carr and a hundred hours puts things in order which we are now proud of. We needed the trailer to store stuff during build. When there is no 914 aft counter balancing trailer, there is a lot of tongue weight on front wheel. The crappy supplied wheel with just a bushing makes rolling difficult, and it fell apart and wore out in short order. Installing a real wheel from McMaster (solid, polyurethane with real bearing) made moving effortless.