|
|
dsc09020
Bill helping by putting a good key on the sockets.
Date: 01/22/2013
Views: 19899
|
|
|
dsc09023
Ensure you have a good key. I used the drill press to create the dimples. These will be filled with 420 and flox when doing the glass layups.
Date: 01/22/2013
Views: 20178
|
|
|
dsc09024
I was really anal about keeping the socket holes tight. This proved to be more work than it was worth and was fighting the tight fit when it came to locating the axles. Do yourself a favor and just make them a little bigger, 1/8 or so. This gap will be
Date: 01/22/2013
Views: 20814
|
|
|
dsc09027
Mixing that expensive 420.
Date: 01/22/2013
Views: 19207
|
|
|
dsc09028
Here the axles are getting the green goop. I used car carnauba wax as a release agent. Worked well jut get it on there thick. We also wrapped the top of the sockets with glad wrap to keep contaminates off of it while we moved it around.
Date: 01/22/2013
Views: 20496
|
|
|
dsc09029
Gear legs clamped in place, no toe in/out per Bud. You cant see it in the photo but I used a green tip .30 bullet as a homemade plum bob that was attached to dead center of the aluminum angle. This helped us keep the guide over the center line. Oh make
Date: 01/22/2013
Views: 19683
|
|
|
dsc09030
Starboard side done.
Date: 01/22/2013
Views: 19009
|
|
|
dsc09032
Port side done.
Date: 01/22/2013
Views: 18133
|
|
|
dsc09033
Port side done.
Date: 01/22/2013
Views: 18160
|
|
|
dsc09034
Starboard side done. Pic taken before a little clean up.
Date: 01/22/2013
Views: 18073
|
